#How to use gm tech 2 scanner manual
#How to use gm tech 2 scanner full
#How to use gm tech 2 scanner software
#How to use gm tech 2 scanner code

Update: via 32MB Software Card, when there is newer version, you can just buy new card to updateР вЂќР’В¤. Multi-langauge: English, Italian, French, Portuguese, German, Spainish, Korean, Japanese, Thai, ChineseР вЂќР в‚¬.

#How to use gm tech 2 scanner full

Top 4 Reason to Get GM Tech2 Full Package:Р вЂќРЎС›. If you need a storage case, please choose SP23 This one is the same as the SP23, the only difference is the package. One Device only Has One 32MB Card As Default, If You Want do more vehicles, Please Buy Additional 32MB Memory Card SO22-DР вЂќР в‚¬. It Can Only Support 12V Cars, No TrucksР вЂќРЎС›. The Vetronix Tech 2 comes with Authentic GM software and provides support for on-board diagnostics on all GM systems 1992 thru 2011.Р вЂќР’В¬ar model supported: GM/SAAB/OPEL/SUZUKI/ISUZU/HOLDENР вЂќР Р‹. The Tech-2 is the same tester GM Technicians use to diagnose GM vehicles. (We offer one vehicle card and one TIS2000 software for free) Road test the vehicle while inspecting that the pedal remains high and firmGM Tech2 Diagnostic Scanner For GM SAAB OPEL SUZUKI ISUZU Holden with TIS2000 Software.When the desired pedal height is achieved, press the brake pedal in order to inspect for firmness.If the brake pedal feels spongy, perform the conventional brake bleed procedure again.(DTC) List and diagnose the appropriate DTC.

#How to use gm tech 2 scanner code

If a DTC is detected, refer to Diagnostic Trouble Code.

Perform the following steps before resuming the bleed procedure:

If the bleed procedure is aborted, a malfunction exists.

Follow the Tech 2 scan tool directions until the desired brake pedal height is achieved.

Select Automated Bleed from the Special Functions menu.

With the scan tool, establish communications with the EBCM.

Turn ON the ignition, with the engine OFF.

Refer to Brake Fluid Loss or Symptoms - Hydraulic Brakes.

Inspect the brake system for leaks and visual damage.

Remove all four tire and wheel assemblies.

Raise the vehicle on a suitable support.

Failure to properly relieve pressure may result in spilled brake fluid causing damage to components and painted surfaces. After exiting the bleed procedure, relieve bleed pressure and disconnect bleed equipment per manufacturers instructions. No further Scan Tool prompts pertaining to the Auto Bleed procedure will be given. Notice: The Auto Bleed Procedure may be terminated at any time during the process by pressing the EXIT button. The automated bleed procedure is recommended when air ingestion is suspected in the secondary circuits, or when the BPMV has been replaced.

The procedure cycles the system valves and runs the pump in order to purge the air from the secondary circuits normally closed off during normal base brake operation and bleeding. If the desired brake pedal height results are not achieved, perform the automated bleed procedure below.

#How to use gm tech 2 scanner manual

Perform a manual or pressure bleeding procedure.